Q: Brokers seem to quote space as both useable and rentable s/f. What is the difference between rentable and useable s/f, and how are they both calculated?
A: The space that a tenant can actually use is called "useable," or sometimes "carpetable," s/f. This may be very important to the tenant in laying out his furniture, but it is not the critical component in calculating rent. The rent in most leases incorporates both the useable s/f, plus the tenant's proportionate share of common areas in the building. The sum of these two is known as the rentable s/f. The difference between the rentable and useable s/f in a building is commonly known as the loss or load factor. As an example, if by measurement it is determined that 15% of a building is devoted to common areas, e.g. lobbies, hallways and lavatories, then this will become the loss factor for every lease in the building.
The measurement and calculation of these figures is by no means an exact science, and a number of standards have been established to bring objectivity into the marketplace. The major standards used in the New York metropolitan area and Long Island are: Building Owners and Managers Association (BOMA), Real Estate Board of New York (REBNY) and American Institute of Architects (AIA). Each has slightly different method on how to measure common areas and perimeter walls.
If you are a tenant, you should be aware that landlords are often deliberately vague on the measurement of loss factor, to the point that it sometimes just becomes another item to be negotiated, like the rent or a work letter. From a space utilization point of view, it is critical that a tenant knows that the useable s/f will be sufficient for his needs. And in our experience, this assurance is only possible with the preparation of a tenant space plan, showing the exact location of each piece of furniture or equipment.
You will most often be quoted rentable s/f by a broker or landlord. The approximate useable s/f may be calculated by multiplying the rentable square footage by the loss factor, and subtracting the result from the rentable s/f. For example, if the landlord quotes the size of a suite at 5,000 s/f "rentable," with a 15% loss factor, you would first multiply 5,000 times 15% to compute the "lost" area of 750 s/f. Subtracting 750 from 5,000 would give you an approximate useable size of 4,250 s/f.
It is very important for a tenant address this issue before a lease is signed, as there is usually little or no recourse after lease execution. Most leases have no direct calculations of either useable or rentable s/f, and if a rentable figure is provided, it is almost always modified with the word "approximate." It is incumbent on a tenant, therefore, to first determine that the suite under consideration is adequate for the proposed use by means of a space plan, and secondly, have some reasonable assurance that the loss factor represented by the landlord approaches reality.
In the end, there are no set formulas or rules that must be followed. The solution is a clear understanding of the actual square footage to be occupied, along with a satisfactory agreement on the rentable s/f in the lease document.
David Hunt, MCR, CCIM, SIOR, is the president of Hunt Construction Services, Inc. and Hunt Corporate Services, Inc., Plainview, N.Y. Tags: